×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Fast busy when using IPC to start an ad-hoc conference call

Unanswered Question
Dec 18th, 2009
User Badges:

CUCM 7.1(3) and IPC 7.0.3.0


When I call from my IPC client to another IPC user and try to initiate an ad hoc conference call I get wave off (fast busy). This also happens when I call our MeetingPlace Express bridge number. I'm guessing this is a codec issue since the bridges use G.711 and IPC is using iLBC. If this is the case would IPC just renegotiate the codec? Or am I missing something else? The bridges work fine when called from an on-net desk phone.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Michael Murray Fri, 12/18/2009 - 08:58
User Badges:

Figured it out:


http://www.cisco.com/en/US/products/sw/voicesw/ps5475/products_tech_note09186a008026d36f.shtml


"Note: When you use Optimize for low bandwidth, it is difficult to connect to some applications that use a different codec other than G.729. For example, Cisco Conference Connection can only use G.711 codec, thus Cisco IP Communicator is unable to dial a MeetMe Conference number."


I also didn't have any G.729 audio ports configured on MeetingPlace Expess. They were all G.711. System Configuration > Meeting Configuration > G.729 ports (cost per port: 5 SRUs)

Rob Huffman Fri, 12/18/2009 - 14:00
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Michael,


Thanks for posting up your solution here


Very kind my friend! (+5)


Cheers!

Rob

Actions

This Discussion