ā12-19-2009 06:46 AM - edited ā03-06-2019 09:01 AM
Hi,
I have a 6509 running CatOS v8.2 (I know it's old and am hopefully upgading in Jan ) and I want to limit one of the 100Mbps ports to rate limit input to 60Mbps.
What's the best way to do this, and what is the command(s).
Thanks for any help.
ā12-19-2009 06:52 AM
Hi,
Check out the below link hope this helps out your query
http://www.cisco.com/en/US/docs/ios/12_2/qos/command/reference/qrfcmd8.html
Regards
Ganesh.H
ā12-19-2009 09:56 AM
Thanks....do you know if there's a similar doc for CatOS??
Or, does anyone know the best command for me to use?
ā12-19-2009 10:06 AM
BlueyVIII wrote:
Thanks....do you know if there's a similar doc for CatOS??
Or, does anyone know the best command for me to use?
Have a look at this doc and come back if you have further questions -
Jon
ā12-19-2009 02:42 PM
Thanks Jon....
I think the policer config I need is :-
set qos policer aggregate WSUS_SERVER rate 51200 burst 61440 drop
However, It's not clear from the document how I apply this to the port??
Any advice greatfully received..
ā12-19-2009 02:57 PM
BlueyVIII wrote:
Thanks Jon....
I think the policer config I need is :-
set qos policer aggregate WSUS_SERVER rate 51200 burst 61440 drop
However, It's not clear from the document how I apply this to the port??
Any advice greatfully received..
You need to use the policer together with an acl, here is an example -
http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00801c8c4b.shtml#catos
Jon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: