ISDN and Dial up Network

Unanswered Question
Dec 18th, 2009

Dear Sirs,

I have an ISDN network as the following:

Main office :

Cisco router 2821


Branches :

- Cisco router 1841

- WIC-BRI- S/T -V3

After I complete the configuration all branches working well but I can't add new branches because there is no ISDN lines available in these places just I found Telephone line (Dial up).

The problem is what I need to add in the main router  ( Hardware and configuration)  to make the main router accept the dial up calling ?

Find the attached image about the network which I need.


ISDN branches are working well only the dial up branch (PC) is not working yet.

Thank you for your help.


[email protected]

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Mon, 12/21/2009 - 09:51

On the hub, you need PVDM2-xDM, where x is 12, 24 or 36 according to number of simultaneous modem calls that you want to support.

On the branches, you can use WIC-1AM that is V.92 modem.

Paolo Bevilacqua Wed, 12/23/2009 - 12:51

Yes, on the motherboard. Hub means the central site of a network.

Please remember to rate posts clicking on the stars below.


This Discussion