1 IP address, 1 device

Unanswered Question
Dec 21st, 2009

After the discovery, my DCR dcontains multiple ip address for a single device.

How do I setup CS so that it grab only one IP address for each device?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Mon, 12/21/2009 - 21:46

What types of devices are exhibiting this?  How are they configured?  Discovery uses the ipAddrTable on devices to resolve duplicates.  Provided the duplicates do not already exist in DCR, Discovery should not be adding them unless they do not support the ipAddrTable, or that table is excluded by an SNMP view.

Actions

This Discussion