Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
823
Views
0
Helpful
3
Replies

Netshow jobs require telnet enable password?

david.fernandes
Level 1
Level 1

‎12-22-2009 08:46 AM

Do netshow jobs require the telnet enable password to run on switches (Cisco 6500 switches in particular)? I'm running a basic netshow job to do "sh ver" and it fails:

ERROR:RME_CDL1031:Transport session to device failed Couldnot enter ENABLE Mode from USER Mode on Device. Couldnot enter ENABLE Mode from USER Mode on Device.

Labels:
0 Helpful
3 Replies 3

Joe Clarke
Cisco Employee
Cisco Employee

‎12-22-2009 08:48 AM

Yes, Netshow must become enabled on the device before it will run commands.

0 Helpful

Howling76
Level 1
Level 1
In response to Joe Clarke

‎04-07-2010 02:30 PM

We use SSH to manage our network. Is there a way to have LMS (4.3.1)  use SSH to execute netshow jobs?

          thx, steve

0 Helpful

yjdabear
VIP Alumni
VIP Alumni
In response to Howling76

‎04-07-2010 02:59 PM

Absolutely, just "promote" SSH above Telnet at " http://yourLMS:1741/rme/DcmaTransportSettings.do ", making sure Application Name is NetShow while making the change.

0 Helpful
Customers Also Viewed These Support Documents