Unanswered Question
Dec 23rd, 2009
User Badges:


I have a FWSM with OSPF with two neighbors all in area 1, it learn inter area and external routes from one of him, my problem is that the FWSM not flood this routes to other neighbor. I make a show ospf and i see the fwsm as ASBR and i dont understand why.

I paste the output from sh run router, show ospf and show ospf neighbor commands

FWSM-USERS# sh run router
router ospf 1
network area 1
network area 1
network area 1
network area 1

FWSM-USERS# sh ospf neighbor
Neighbor ID     Pri   State           Dead Time   Address         Interface       1   FULL/BDR        0:00:38     svi       1   FULL/DR         0:00:30     svi_vrf

FWSM-USERS# sh ospf

Routing Process "ospf 1" with ID and Domain ID
Supports only single TOS(TOS0) routes
Does not support opaque LSA
It is an autonomous system boundary router
Redistributing External Routes from,
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Minimum LSA interval 5 secs. Minimum LSA arrival 1 secs
Number of external LSA 7. Checksum Sum 0x 48992
Number of opaque AS LSA 0. Checksum Sum 0x     0
Number of DCbitless external and opaque AS LSA 1
Number of DoNotAge external and opaque AS LSA 0
Number of areas in this router is 1. 1 normal 0 stub 0 nssa
External flood list length 0
    Area 1
        Number of interfaces in this area is 6
        Area has no authentication
        SPF algorithm executed 79 times
        Area ranges are
        Number of LSA 68. Checksum Sum 0x2218b0
        Number of opaque link LSA 0. Checksum Sum 0x     0
        Number of DCbitless LSA 1
        Number of indication LSA 1
        Number of DoNotAge LSA 0
        Flood list length 0


Best Regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion