ciscoworks -- netconfig fails

Unanswered Question
Dec 23rd, 2009
User Badges:

Hi ciscoteam,

i have lms 2.6 and i am trying to do a netconfig job via rme >tools>netshow>netshow jobs>create -- to execute the commands "show pas vsa statistics and show crypto eli


Initially i got the error ERROR:RME_CDL1045:Pre-Device deploy operation failed, Device not found in RME..Then i stopped the ciscoworks services and rmedb password has been resetted. Later on I deleted the device in common services and added it again. Then i did an update inventory thru device center and again tried to do a netconfig job. There i found that the job has been failed with the error message as " status->failure, Protocol used->Telnet,   Message->Deploy command partially failed. When i click on the "Failure" link, i  could see that output for both the commands were showing properly in the window..


Can you please help me on this as i am failed to understand the problem..


many thanks in advance


~pr

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Wed, 12/23/2009 - 09:42
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Post the output of the command as seen by Netshow.

Sec IT Wed, 12/23/2009 - 16:45
User Badges:

Hi clarke,

pls find the attached error messages/outputs after the netshow job.


i have erased the device ip and hostname of the router for security reasons in the attached screenshots.


~pr

Joe Clarke Wed, 12/23/2009 - 18:00
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Screenshots are not helpful.  I need the full output in text format.

Actions

This Discussion