CTS Manager & Multipoint connectivity with CA Spectrum Management Software through SNMP v2

Unanswered Question
Dec 23rd, 2009
User Badges:

I am configuring CTS Manager & Multipoint to interface with CA Spectrum management software through SNMP v2, the administrator of the CA Spectrun Software is asking for the MIBs & OID. From where I can get the MIBs & OIDs and which MIBs & OIDs I should send to CA Spectrum Management software administrator to work it properly with CTS Manager & Multipoint. CTS Manager & Multipoint are running software ver 1.6.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
dillarw Wed, 12/23/2009 - 13:19
User Badges:
  • Cisco Employee,

MIB information for the CTM and CTMS products can be found at the following locations:

CTS Manager:


Chapter: Supported MIBs for Cisco TelePresence Manager



Chapter: Configuring CTMS Administration Software.

Half Way down the document below table 4-6 on SNMP Settings, It lists the FTP server where MIB support is listed.

Let us know if this does not provide what you need.


Wayne D.

rehan_uet Thu, 12/24/2009 - 06:08
User Badges:

And what are MIBs & OIDs required for CTS 3000 System.


This Discussion