PAP2 V3 telephone adapter in SOS mode (I think)

Unanswered Question
Dec 23rd, 2009

Hi, I have a Linksys PAP2 phone adapter with V3 stamped on the circuit board.  After upgrading the firmware the red power LED's are now blinking erratically, apparently in SOS mode ..  3 short, 2 long, 3 short.  My router is not assigning it an IP address and there is no dial tone in IPV.  Do you happen to have some sort of recovery tool that might bring this unit back to life?  Any help is very appreciated!

Serial # is:  FH9004G14277
I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion