Bricked NSS4000

Unanswered Question
Dec 24th, 2009
User Badges:

After unsuccessfull firmware upgrade my NSS4000 does not boot. It simply shows yellow power led, then blinking green power led.

I tested the "red blinking" recovery procedure by usb but it doesn't work.


What I can try before RMA it?

Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Alejandro Gallego Sat, 12/26/2009 - 20:20
User Badges:
  • Cisco Employee,

Try removing ALL drives once the NSS is shutdown and then reboot (with drives ejected). If you end up in the same place; blinking Green Power light, perform a factory reset and try again. Factory reset will not erase disk data, just settings. If you are still not successful call Small Business Support Center.

giolam Sun, 12/27/2009 - 01:03
User Badges:

I did it. Same behaviour. So last resource is RMA.


Thanks

Ela Snessjna Mon, 01/04/2010 - 23:59
User Badges:

I have the exact same problem! Any solution for it? At the moment the thing is down :(

Actions

This Discussion