N7K

Unanswered Question
Dec 24th, 2009
User Badges:

Got 3 Qs:

1) how do you save the config on N7K, or on NX in general?

2) How to do image upgrade?

3) Do I need to congif STP? and if so, do I need to config a switch as root? & how I can do that?

Thx.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mohAmed khAdr Fri, 12/25/2009 - 13:01
User Badges:

What am asking is: do you just:  wr mem like IOS to save the config,.... or it's like the CatOS..just enter2wice.

Thx.

Jerry Ye Wed, 12/30/2009 - 15:33
User Badges:
  • Cisco Employee,

wri mem is not a valid CLI in the NXOS, you have to use copy run start.


For software upgrade procedure, please check out the upgrade guide.

http://www.cisco.com/en/US/docs/switches/datacenter/sw/4_2/nx-os/upgrade/guide/Cisco_Nexus_7000_Series_NX-OS_Software_Upgrade_and_Downgrade_Guide__Release_4.2_chapter1.html


By default, STP is disabled in NXOS. If you have the proper license, you can enable STP, and configure it to fit your environment.


Regards,

jerry

mohAmed khAdr Wed, 02/10/2010 - 14:28
User Badges:

Jerry,

Can you pls. avise on config redundancy for sup 1 on n7k?

Thx.

Jerry Ye Wed, 02/10/2010 - 15:29
User Badges:
  • Cisco Employee,

Can you post the output of the following commands after inserting the module standby SUP


show system redundancy status

show module

show boot auto-copy


Regards,

jerry

Actions

This Discussion

 

 

Trending Topics: Storage Networking