Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1754
Views
0
Helpful
6
Replies

N7K

mohAmed khAdr
Level 1
Level 1

‎12-24-2009 06:14 PM

Got 3 Qs:

1) how do you save the config on N7K, or on NX in general?

2) How to do image upgrade?

3) Do I need to congif STP? and if so, do I need to config a switch as root? & how I can do that?

Thx.

Labels:
0 Helpful
6 Replies 6

mohAmed khAdr
Level 1
Level 1

‎12-25-2009 01:01 PM

What am asking is: do you just:  wr mem like IOS to save the config,.... or it's like the CatOS..just enter2wice.

Thx.

0 Helpful

ieffinger
Level 1
Level 1
In response to mohAmed khAdr

‎02-12-2010 10:46 AM

Hey Mohamed,

If you want to use the shorthand for write mem aka wr you can use the following command in configuration mode:

cli alias name wr copy run start

This will allow you to copy the running config to the startup config with the familiar wr syntax.

0 Helpful

Jerry Ye
Cisco Employee
Cisco Employee

‎12-30-2009 03:33 PM

wri mem is not a valid CLI in the NXOS, you have to use copy run start.

For software upgrade procedure, please check out the upgrade guide.

http://www.cisco.com/en/US/docs/switches/datacenter/sw/4_2/nx-os/upgrade/guide/Cisco_Nexus_7000_Series_NX-OS_Software_Upgrade_and_Downgrade_Guide__Release_4.2_chapter1.html

By default, STP is disabled in NXOS. If you have the proper license, you can enable STP, and configure it to fit your environment.

Regards,

jerry

0 Helpful

mohAmed khAdr
Level 1
Level 1
In response to Jerry Ye

‎01-05-2010 12:41 PM

Thx. jerry,

0 Helpful

mohAmed khAdr
Level 1
Level 1
In response to Jerry Ye

‎02-10-2010 02:28 PM

Jerry,

Can you pls. avise on config redundancy for sup 1 on n7k?

Thx.

0 Helpful

Jerry Ye
Cisco Employee
Cisco Employee
In response to mohAmed khAdr

‎02-10-2010 03:29 PM

Can you post the output of the following commands after inserting the module standby SUP

show system redundancy status

show module

show boot auto-copy

Regards,

jerry

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents