Netmanager 1.1----Customizing Physical Topology Views

Unanswered Question
Dec 25th, 2009

Hi,

I have netmanager 1.1

I have 2 queries on this:--

1. The Physical topology view is not proper..Can i customize the view based upon my requirement like Core switch, distribution switch, access switch etc so that a n/w hierarchy is maintained....

2. Can names be in plane instead of IP in Physical Topology view for easier identification purpose...

Attached is the topology that i am getting..

Rgds,

Partha

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Nael Mohammad Wed, 12/30/2009 - 15:03

1. The device topology is displayed as the way its connected in your environment and cannot be grouped .

http://www.cisco.com/en/US/docs/net_mgmt/cisco_netmanager/1.1_data/user/guide/topo.html#wp1040314

2.   Displaying IP Address or Display Name

To have devices display on the Physical Connectivity View by IP address, display name, or both, do the following:

Step 1    Select GO > Configure > Physical Connectivity View Settings.

Step 2    Check IP address, Display Name, or both.

Actions

This Discussion