cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
575
Views
0
Helpful
1
Replies

Netmanager 1.1----Customizing Physical Topology Views

acharyr123
Level 3
Level 3

Hi,

I have netmanager 1.1

I have 2 queries on this:--

1. The Physical topology view is not proper..Can i customize the view based upon my requirement like Core switch, distribution switch, access switch etc so that a n/w hierarchy is maintained....

2. Can names be in plane instead of IP in Physical Topology view for easier identification purpose...

Attached is the topology that i am getting..

Rgds,

Partha

1 Reply 1

Nael Mohammad
Level 5
Level 5

1. The device topology is displayed as the way its connected in your environment and cannot be grouped .

http://www.cisco.com/en/US/docs/net_mgmt/cisco_netmanager/1.1_data/user/guide/topo.html#wp1040314

2.   Displaying IP Address or Display Name

To have devices display on the Physical Connectivity View by IP address, display name, or both, do the following:

Step 1    Select GO > Configure > Physical Connectivity View Settings.

Step 2    Check IP address, Display Name, or both.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco