Clientless SSL VPN broken after upgrade 8.0(4) -> 8.0(5) ASA 5510

Unanswered Question
Dec 29th, 2009

I've got 3 ASA 5510, upgraded them all from 8.0(4) to 8.0(5) and ASDM 6.2(3)

Then I found out none of the three device responded anymore to WebVPN,

like there is nothing listening to https on the outside interface

I downgraded one back to firmwate 8.0(4) and everything worked just fine again.

Any ideas?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
RicheeJJJ_2 Wed, 12/30/2009 - 13:01

I'm experiencing this same problem today. Did you find a solution yet?

riccardo-patti Thu, 12/31/2009 - 05:33

Have you backed up the all the config files of the appliance through

the utility into the asdm and restored it after the upgrade was done? Mon, 01/04/2010 - 00:38

I've done the upgrade via the tools menu in  the Cisco ASDM, one whould expect that this should be the right way, since it was specially designed for upgrading.

(Ofcourse I make backups of my routers/firewalls etc. this is done on a daily basis by Kiwi Cattools) Mon, 01/04/2010 - 00:36

Unfortunatly not yet, but I'm about to create a TAC request. When I've got the answer I will post it here.


This Discussion