I need setup instructions for rdp using gui interface

daren.donohoo · ‎12-29-2009

I have a small business that I am trying to use multiple static IP's to route rdp to particular workstations. I have done this many times with a pix but I'm just stumped on the asa 5505. I have it setup using one static for the outside internet access but haven't made it much further than that. I'm sure it's simple but it just isn't as straight forward as the pix.

Thanks,

Daren

Ganesh Hariharan · ‎01-13-2010

Hi Daren,

Check out the below link hope this helps out your query fro configuring rdp port redirection in internal lan

http://remotesupportsoftware.blogspot.com/2008/10/configure-rdp-port-forwarding-on-cisco.html

Regards

Ganesh.H