Switch Command doesn't show output.

Unanswered Question
Jon Marshall Tue, 12/29/2009 - 08:10
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

[email protected]

I type "ip accounting mac-address" in my cisco switch and the commands are there but it does not show any output. Any ideas?


Not clear what output you are expecting to see. "ip accounting mac-address" enables mac-address accounting on the switch. If you want to see the result of enabling this command use the "sh interface mac" global command.



This Discussion