ZBPF and SDM

Unanswered Question
Dec 30th, 2009
User Badges:

I am configuring Zone Based Policy Firewall using SDM . As per my knowledge if you use an older version of SDM or IOS you will get CBAC there in SDM but starting IOS 12.4(6)T that feature would be replaced with ZBPF which has got zones rather than those ACL . However when I am going to Configure - Firewall - Basic/Advance and when i Finish up with the configuration I cee that CBAC has been applied .



I am using SDM v2.5


and I have tried the following IOS


c2691-advsecurityk9-mz.124-6.T

c2600-advsecurityk9-mz.124-15.T3

c2600-adventerprisek9-mz.124-15.T9




Feature nagivator says that these both IOS supports ZBPF but I am not getting them in SDM .


Note: I am using GNS3 to emulate these stuff


Kindly help

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
communication.boy Sat, 01/02/2010 - 17:41
User Badges:

Thanks Soares ,

                       It looked like it was a problem with GNS3 , I tested the same stuff in my office PC and everything worked fine .




BIG FAT WARNING : NEVER RELY ON EMULATORS





cb,

Actions

This Discussion