12-30-2009 11:04 AM - edited 03-11-2019 09:52 AM
I am configuring Zone Based Policy Firewall using SDM . As per my knowledge if you use an older version of SDM or IOS you will get CBAC there in SDM but starting IOS 12.4(6)T that feature would be replaced with ZBPF which has got zones rather than those ACL . However when I am going to Configure - Firewall - Basic/Advance and when i Finish up with the configuration I cee that CBAC has been applied .
I am using SDM v2.5
and I have tried the following IOS
c2691-advsecurityk9-mz.124-6.T
c2600-advsecurityk9-mz.124-15.T3
c2600-adventerprisek9-mz.124-15.T9
Feature nagivator says that these both IOS supports ZBPF but I am not getting them in SDM .
Note: I am using GNS3 to emulate these stuff
Kindly help
01-01-2010 09:04 AM
Hi,
Try this image: 12.4(15)T11 ADVANCED ENTERPRISE SERVICES
The link below explains how to proceed with the configuration on SDM:
Br,
01-02-2010 05:41 PM
Thanks Soares ,
It looked like it was a problem with GNS3 , I tested the same stuff in my office PC and everything worked fine .
BIG FAT WARNING : NEVER RELY ON EMULATORS
cb,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide