CUCM Lab enviroment

Unanswered Question
Jan 1st, 2010

Hello, im getting ready to take the CIPT I exam and i installed a CUCM 6.0 on a virtual machine, but i have no clue hot to get to the GUI from the CLI,

I can ping my virtula machine from the host, but i cant access throug the brownser either.

And the book that im following " Implementing Cisco Unified Communications Manager Part 1 CIPT1 Authorized Self Study Guide" doesnt say anything about it.

Can anybody help me ?

Thanks in advance.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
c.rodriguezesteban Fri, 01/01/2010 - 23:13

That wasnt the problem but it put me on the correct direction, all the services are stoped so im doing a new installation, i was using 30 gb of hard disk i readed that i need 74 is that right?.

Id like to rate, but i cant see how with that link.




This Discussion