01-04-2010 04:08 AM - edited 03-18-2019 10:58 AM
Hi,
I have CME in one of our office location with SIP based Connection over internet with a E1 output ( SIP GW box ) to the Cisco router.
The SIP provider is asking me to configure the Cisco E1 card in TE mode, How do i configure that.
Please help!
Arif
01-04-2010 10:03 AM
controller e1 ..
clock source internal
int serial x/x/x:15
isdn protocol-emulate network
That's it.
01-04-2010 10:30 PM
Hi ,
Thanks for the reply,
I have peculier problem after the changes , like when i make a out going call I am not able to hear the ringing sound , I will hear the voice only after
the calls is answered by the remote end.
The incoming calls works fine.
What do you think could be problem ?
Arif
01-05-2010 03:54 AM
Send "debug isds q931" and "term mon".
Please remember to rate useful posts clicking the stars below.
01-05-2010 04:20 AM
Under the POTS dialpeer add the following:
progress_ind alert enable 8
01-05-2010 05:38 AM
01-05-2010 05:55 AM
You are sending out the same incoming call.
You must configure so that 932417563 rings somewhere, an ephone-dn or what you want.
Please remember to rate useful posts with the scrollbox below.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide