cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
652
Views
0
Helpful
3
Replies

duplex mismatch

alex goshtaei
Level 1
Level 1

Hi All,

there are UC520 and IAD devices. in IAD, fa interface has "duplex full" and in UC520, fa interface has "duplex auto". when I do "show interface fa 0/0" in UC520, I see "duplex half" and I am receiving lots of collision errors.

any suggestion would be very appreciated.

Alex

3 Replies 3

ansalaza
Level 1
Level 1

Hello Alex,

Both       sides of a link should have auto-negotiation on, or both sides should have it       off.

http://www.cisco.com/en/US/tech/tk389/tk214/technologies_tech_note09186a0080094781.shtml#when

HTH,

You have a duplex mismatch.

Here is a guide http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00800a7af0.shtml

NIC - Auto.................Switchport - Auto     GOOD

NIC - 100/Full

Sorry My other post was incomplete.

Here is the link  http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00800a7af0.shtml

See table 1

Based on that you have a duplex mismatch.

Please rate all posts that help.

Mike

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: