TPC Set to Zero by Default?

Unanswered Question
Jan 4th, 2010
User Badges:

I'm running 6.0.188.0 on a 4402-25 controller, with RMM off.  I have set the TPC at a fixed value of '1'.  However, new APs that land on the controller show up with a power level of 0, with the asterisk indicating that this is the global setting.  I still have to check if WCS is configured differently, but the local config on the controller would/should override WCS.  Any thoughts?


Regards,
Scott

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion