4500 SNMP Module alarms traps

Answered Question
Jan 4th, 2010

I am trying to find the correct configuration for when modules from 4500 series devices are removed or fail an SNMP trap will be sent.

So far I can not find any documentation or supporting command that will trigger this.

The command on the 6500 series does not exist on the 4500s.  " snmp-server enable traps module "

Version:

Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASEK9-M), Version 12.2(53)SG, RELEASE SOFTWARE (fc3)

Please help, Thank You!

I have this problem too.
0 votes
Correct Answer by Joe Clarke about 6 years 11 months ago

I believe you have "snmp-server enable traps fru-ctrl".  That should enable the cefcModuleStatusChange traps which will be sent when a module changes state.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joe Clarke Mon, 01/04/2010 - 13:30

I believe you have "snmp-server enable traps fru-ctrl".  That should enable the cefcModuleStatusChange traps which will be sent when a module changes state.

Andy Mikulas Tue, 01/05/2010 - 05:12

Thanks!

The command originally didn't work by itself, but after come changes to the other SNMP configurations the traps were then received.

SNMP configurations below:

Switch#show run | inc snmp

snmp-server community (removed) RW 5

snmp-server trap-source Vlan411

snmp-server chassis-id (Removed)

snmp-server enable traps fru-ctrl

snmp-server enable traps entity

snmp-server enable traps envmon fan temperature

snmp-server host *.*.*.* (Removed)  fru-ctrl envmon

Logging:

Switch#show run | inc log

service timestamps log datetime localtime

logging buffered 16384

logging trap notifications

Actions

This Discussion