Cisco 3545 MCU/EMP

Unanswered Question
Jan 5th, 2010

Hello all,

I'm deploying a videoconference solution with a Cisco 3545 with one MCU and one EMP. I've done the basic configurations. The MCU has the ip and the EMP with the, mask The problem is that the EMP card never appears in the Media Processing tab in the MCU of the MCU admin page, and on the EMP console keeps popping up the message "NO MCU detected at this IP address:".

Do you have any idea?

Best regards.

I have this problem too.
2 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion