MRTG: Etherchannel (Port Monitoring)

Answered Question
Jan 5th, 2010
User Badges:

Q. Can MRTG monitor a etherchannel circuit (3 x 1GB Dot1q) and deliever correct stats?


Q. Does traffic load balance over a etherchannel (Dot1q) circuit?


Thanks,

Colm

Correct Answer by Joe Clarke about 7 years 4 months ago

Load balancing is enabled by default.  Use the "show etherchannel load-balance" command to see the current algorithm.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
colmgrier Tue, 01/05/2010 - 12:42
User Badges:

Hi Joe,


Are etherchannels load blanacing  by default on 6500 switches, or do I need to configure globally?


port-channel load-balance {src-mac | dst-mac | src-dst-mac | src-ip


show etherchannel load-balance



Thanks,

Colm

Correct Answer
Joe Clarke Tue, 01/05/2010 - 13:10
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Load balancing is enabled by default.  Use the "show etherchannel load-balance" command to see the current algorithm.

Actions

This Discussion