01-06-2010 06:50 AM - edited 03-11-2019 09:54 AM
Hi !
I need for test purposes to initiate tcp traffic from my router to the internet
i have set an inspect list on the outbound interface:
router(config)# int eth0
routert(config-if)# ip inspect myfw out
but the tcp sessions initiated from the router are not added int the inspection table and the tcp packets are dropped on their way back
Is there a solution to do this ?
Regards,
\François
01-06-2010 08:39 AM
If what you're meaning is traffic initiating from the router itself like for example if you want to telnet from the router you need to add a statement in your `ip inspect` config.
What you need is the `router-traffic` keyword after your inspect configuration.
ip inspect myfw tcp router-traffic
01-07-2010 01:55 AM
Thank you!
This is exactly what i was meaning !
01-06-2010 08:49 AM
Hi,
Check out the below link hope this will clear your query !!
Regards
Ganesh.H
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: