01-06-2010 11:43 AM - edited 03-04-2019 07:08 AM
Hello,
I need help in converting my E1 internet connection to my router.
I have a modem from my isp which has two bnc connections.... one labeled "in" and one labeled "out" both at E1 75 ohms...
I have a cisco router with an E1 Wic card installed (rj45)...
I need to convert the signal. I have a balun and a 10 base2 to 10 baset converter.
I have tried both individually and am not getting results.
Am I on the right track?? is there something anyone can suggest?? or where to purchase it??
I would really appreciate any help.
Thanx.....Omar
Solved! Go to Solution.
01-06-2010 12:28 PM
VWIC2-1MFT-T1/E1 - 1 PORT RJ-48 MULTIFLEX TRUNK - T1/E1
01-06-2010 11:57 AM
Which card do you have? send "show diag".
01-06-2010 12:28 PM
VWIC2-1MFT-T1/E1 - 1 PORT RJ-48 MULTIFLEX TRUNK - T1/E1
01-06-2010 01:32 PM
You do not need a balun.
Under controller E1, configure line-termination 75.
Then make an appropriate cable, or buy the cisco one.
Please remember to rate useful post clicking on the stars below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: