Starting with Mesh1520

Unanswered Question
Jan 6th, 2010
User Badges:

The WLC is running the software version 5.2.193, which support the 1524 LAPs. I enter the MAC Address in the MAC Address Filter. I connect the LAP to switch and this LAP was registered in the WLC.  In the configuracion of the LAP I set the "AP Role" to RootAP, and  the field "Bridge Group Name" was completed with a specific name. Then, I connect a second LAP to Switch, the LAP was registered in the WLC. The setting applied to second lap, was, "AP Role" to MeshAP and the field "Bridge Group Name" was completed with the same specific name, entered in the RootAP. Then, I save the configuration, and disconnect the MeshAP but the mesh is not established. Am I missing some configuration?


WLC Model : AIR-WLC2106-K9
AP Model: AIR-LAP1524PS-A-K9


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion