i trie to put in a banner on a catalyst 6509e. there is no error message at all. the banner i trie to put in works on other switches without problems.
but when i look at the config the banner entry is empty:
banner exec ^C
banner login ^C
the only that is different to all other switches is that this switch is in a VSS bundle.
(s72033_rp-IPSERVICESK9_WAN-VM), Version 12.2(33)SXI, RELEASE SOFTWARE (fc2)
any ideas, bug or ???, regards Reinhold.
there are bugs like
CSCei52830 Bug Details
|Banner command sync is broken by CSCin86483|
| Symptoms: The banner motd command may not properly function when you enter a|
message-of-the-day (MOTD) through the banner motd
d message d command because the d message
d argument of the command may not be synchronized to the standby RP.
Conditions: This symptom is observed on Cisco router or switch that is
configured for SSO.
CSCsv54929 Bug Details
|Cannot save banner bigger than 2048 characters|
Banner bigger than 2048 chracters does not show up in show run after
a reload. "sh run" or "wr mem" reports traceback error.
or the following one:
CSCsu57889 Bug Details
|banner exec CLI ignoring lines starting with #, !, and ;|
Banner lines starting with "#", "!", or ";" characters are not stored in the running configuration.
No specific conditions.
Hope to help