PRI Network Service ACCUNET

Answered Question
Jan 8th, 2010
User Badges:
  • Bronze, 100 points or more

I have a customer with a PRI configured on the callmanager as MGCP, protocol type PRI 5E8, network service protocol PRI 5E8, and under route pattern, network service is set to ACCUNET switched digital service.  It is not working in SRST, so I'm looking for how I would configure the PRI with these settings in H.323 to carry that over for SRST. 


Can someone point me to the correct H.323 configuration for this particular kind of PRI?


Thanks!


Jim

Correct Answer by paolo bevilacqua about 7 years 6 months ago

Correct.


Please remember to rate useful posts clicking on the stars below.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
paolo bevilacqua Mon, 01/11/2010 - 15:44
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Nothing special about it, will work with any setting eg pri-5ess, actually they can "emulate" a particular switch type upon your request.

astinus Tue, 01/12/2010 - 06:37
User Badges:
  • Bronze, 100 points or more

So no need for any other special configuration to have it work in H.323/SRST (no nsf or anything), just set the switch type and we should be good to go?


Thanks,


Jim

Correct Answer
paolo bevilacqua Tue, 01/12/2010 - 06:54
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Correct.


Please remember to rate useful posts clicking on the stars below.

astinus Sat, 01/16/2010 - 08:28
User Badges:
  • Bronze, 100 points or more

Thanks a bunch Paolo.  Turned out an incorrect dial-peer was causing their calls to fail, didn't have to do anything special to route calls out over ACCUNET.

Actions

This Discussion

Related Content