How do you configure snmp trap destiantions on UCM 6.1

Answered Question
Jan 12th, 2010
User Badges:

Is there a way to configure the SNMP trap service (if there is one) on UCM 6.1?


Thanks!

Chris

Correct Answer by Jaime Valencia about 7 years 4 months ago

Yes, under serviceability


Understanding Simple Network Management Protocol

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/service/6_1_1/admin/sasnmdes.html


HTH


java


If this helps, please rate


www.cisco.com/go/pdihelpdesk

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Knightvoice_2 Tue, 01/12/2010 - 12:38
User Badges:

Thanks! Is there a way to test it easily? I have gone through all of the steps but our monitoring system doesn't seem to be getting them.The guy in charge of it says his side is set up correctly.

Jaime Valencia Tue, 01/12/2010 - 18:33
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

The config is really straight-forward, not sure if there might be some service related to this.

I'll check that tomorrow


Have you checked nothing is blocking the SNMP traffic from CUCM?


HTH


java


If this helps, please rate


www.cisco.com/go/pdihelpdesk

Actions

This Discussion