01-13-2010 04:53 AM - edited 03-17-2019 09:54 PM
and Hello,
we are testing a CTS500 and CTS1100 for our customer. I set up the systemas mentione din the Guides for CTS & UCM. On the UCM I set up both systems to the same Quality (per Display). I treid it with „Heighest Detail, Best Motion: 1080p“and with „Heigh Detail, Best Motion: 720p“. Both systems are registered on the UCM. But everytime I set up a call from one system to the call setup is ending with the following error message in the log file: Call ended due to video quality configuration mismatch
The bandwidth between the system is 10mbit. I read the section in the troubleshooting guide but as described both systems are at
„Heigh Detail, Best Motion: 720p“. Is there anyone with a hint?
Thanks for helping
Andreas Eichhorn
Solved! Go to Solution.
01-14-2010 01:53 AM
are they both in the same device pool
and what is the codec you use under the regon setting ?
01-14-2010 01:53 AM
are they both in the same device pool
and what is the codec you use under the regon setting ?
01-16-2010 09:54 AM
You gave a ggod hint for that. The problem was that the video bandwidth in the region settings was too small for CTS. After I raised it from 384kbit to 4mbit I could start the conference between two CTS.
But now I could see a new problem: The call between CTS500 and CTS1100 is starting and the audio part is ok. But both sides could only see a picture that is equal to fog where you could see only 10cm. Cameras and Display are ok - I tested this with the hardware tests on both systems. When I do these tests I could see the picture from myself but in the conference call I could not see the picture of the other part.When I take a look on the logfiles I could see that both systems sent and recieve H264 pakets for video.
Did you know such an error?
01-16-2010 03:37 PM
hi
The region should be configured for AAC/Wideband audio (which as of release 5.1.1 or higher of CUCM permits up to 256 Kbps of audio per call) and a video bandwidth of at least 12500 Kbps (12.5 Mbps). As of release 5.1.1 or higher of CUCM, the maximum video bandwidth permitted is 32,256 Kbps.
http://www.cisco.com/en/US/docs/solutions/Enterprise/Video/tpcmdep.html
check this point and see if you gonna see any diffrence or not
good luck
please rate the helpful post
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide