01-13-2010 07:29 AM - edited 03-15-2019 09:04 PM
dial-peer voice 10 voip
description **International Outgoing Call to SIP Trunk**
translation-profile outgoing PSTN_Outgoing
destination-pattern .T
voice-class codec 711
session protocol sipv2
session target ipv4:66.60.xx.xx
dtmf-relay rtp-nte
fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback pass-through g711ulaw
no vad
!
dial-peer voice 1 pots
destination-pattern 214638....
direct-inward-dial
port 1/0:0
!
dial-peer voice 2 pots
destination-pattern 214630....
direct-inward-dial
port 1/0:0
!
Is the existing config. Well actually there are a couple more dial peers but with specific #'s on them, dial-peer voice 3 and 4 pots
The isue is they want to call a 214638xxxx Number that isn't on their PBX, so when they try to call it, it makes the dial-peer voice 1 pots
Where in the config would I put that specific number to have it work? I was thinking
dial-peer voice 11 voip
destination-pattern 214638XXXX
Is that correct? Would I need to delete all dial-peers and re-add them with 11 in the correct order?
Thanks,
Tim
Message was edited by: TIMOTHY GRIMES
Solved! Go to Solution.
01-13-2010 07:52 AM
Correct, simply add a dial peer with closer match and it will be used.
HTH,
Chris
01-13-2010 07:52 AM
Correct, simply add a dial peer with closer match and it will be used.
HTH,
Chris
01-14-2010 07:28 AM
I was unable to setup a proper test enviroment - based on the customer's setup vs my equipment.
However - at the end of the day we tested the new dial-plan and it worked.
Thank you,
Tim
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: