unable to get ATA to pull ip address in CCM ver 6

Unanswered Question
Jan 13th, 2010

Hi Guys,

            I am trying to configure an ata 186 and I have already configured it in the CCM admin page with the mac address, phone # ,devie pool and locatio n and all the necessary parameters for the ATA  but somehow . I am unable tpo pull an ip address from the CCM. The phones are coming up  fine after configuration. I am using H323 and I am even seeing the mac address in the mac address table either. The switch is not recognnizing the devise either.

            I was meant to understand that this ATA was a used one and it used to work in anther location previously. Please help.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Adam Thompson Wed, 01/13/2010 - 12:56


What is the speed/duplex on the network port configured for? ATA 186 devices can only communicate at 10/Half, I also believe that it is not capable of auto-negotiation. I have had this problem in the past and hard coding the speed/duplex fixed it for me.



Please rate if helpful


This Discussion