I have nexus 5000 series device and on the ethernet interface I see the jumbo frames getting increased were as I have not configured jumbo releted cmds on the device/interface.
I would like to know if the Packet which is greater that 1500 bytes going though the interface will be recorded as Jumbo frames on the interface?
Ethernet5/1 is upardware: 1000/10000 Ethernet, address: 00ab.bca8.69d1 (bia 00ab.bca8.69d1)
Description: link to seki85hubdd1
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Port mode is trunk
full-duplex, 10 Gb/s, media type is 1/10g
Beacon is turned off
Input flow-control is off, output flow-control is off
1 minute input rate 3450 bits/sec, 6 packets/sec
1 minute output rate 3460bits/sec, 1 packets/sec
34000111 input packets 11998866 unicast packets 3083 multicast packets
3455 broadcast packets 4545678 jumbo packets 0 storm suppression packets
122345 output packets 3083 multicast packets
21234 broadcast packets 45325 jumbo packets
0 input error 0 short frame 0 watchdog
Thanks in advance.