Hi Edison,

if i use 192.168.1.1  and then reload my switch it shows old time not current time.

it does not sync

sh ntp status
Clock is unsynchronized, stratum 16, no reference clock
nominal freq is 250.0000 Hz, actual freq is 249.9937 Hz, precision is 2**18
reference time is 00000000.00000000 (17:00:00.000 MST Wed Dec 31 1899)
clock offset is 0.0000 msec, root delay is 0.00 msec
root dispersion is 0.00 msec, peer dispersion is 0.00 msec
2950T2#sh ntp status
Clock is unsynchronized, stratum 16, no reference clock
nominal freq is 250.0000 Hz, actual freq is 249.9937 Hz, precision is 2**18
reference time is 00000000.00000000 (17:00:00.000 MST Wed Dec 31 1899)
clock offset is 0.0000 msec, root delay is 0.00 msec
root dispersion is 0.00 msec, peer dispersion is 0.00 msec

2950T2#sh clock
*17:03:33.252 MST Sun Feb 28 1993

What's the status of 192.168.1.1 ?

Let's see show ntp associations from both devices.

Hi Edison

thanks for reply

from switch

2950T2#sh ntp associations

      address         ref clock     st  when  poll reach  delay  offset    disp
~192.168.1.1      0.0.0.0          16     4    64    0     0.0    0.00  16000.
* master (synced), # master (unsynced), + selected, - candidate, ~ configured

Router

2650#sh ntp associations

      address         ref clock     st  when  poll reach  delay  offset    disp
~132.163.4.101    .ACTS.            1  25873    64    0    81.4   -0.20  16000.
~128.233.3.100    0.0.0.0          16     -    64    0     0.0    0.00  16000.
~150.101.254.110  0.0.0.0          16  1805    64    0     0.0    0.00  16000.
* master (synced), # master (unsynced), + selected, - candidate, ~ configured

Your router is not on sync with the NTP servers.

A "*" next to the NTP server would indicate if this router is on sync.

Until then, this router can't provide time to other devices.

hi Edison,

thanks for reply i was able to fix the NTP issue now

many thanks

mahesh

Hi Ganesh,

thanks for great reply.It was good note from you.

Mahesh