Safenet Softremote VPN Client 10.8.3 with Pix 6.3(5)

Unanswered Question
Jan 17th, 2010

Dear All,

I am using the VPN software in object, for the first time.

I have just configured the vpn tunnel and the phase I And Phase II are ok.

So the tunnel go up, but the SafenetVPN client do not create the virtual adapter!!!!

I think that the problem is due by the pix config, the Cisco command reference guide 6.3 tells about vpngroup command:

"Supports Cisco VPN Client Version 3.x (Cisco Unified VPN Client Framework) and Easy VPN Remote

Infact to exchange the isakmp key I have used :

isakmp key ******** address netmask no-xauth

instead of the vpdngroup command.

My question is, there is a way to configure the ip local pool and the wins and dns setting for the other VPN Clients?

Best regards,


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion