Thanks for the reply, so from the URL Link, myself understand that to connect teleco and voice gateway we need FXO card only, please correct me if I am wrong ?

One more question, I am integrating FXO port with MGCP gateway, how to ring an IP Phone with FXO integration.

I have one PSTN line 22445566, want to integrate this line with FXO, then the incoming call should be get land on IP Phone.

Regards,

Bala.

Could you please help me with more configuration example..it will help me lot.

It is poosible to connect FXO to a teleco line and we can call an IP Phone in the CUCM cluster, please light me with more information on this.

Hello,

Please check form cisco site the cme configurtion for PSTN line on FXo card.

the configuration is not too much, it is just like it:

insert the card

check in the router by show version or show diag

then u see port 0/0/0 or 0/0/1.....where u pu the card in the slot of router

then use connection plar command

create a dial peer for incominga dn for outgoing

adn assing this port under outgoing dialpeer.

that is the final point to do it completeand get call.

for trace chekc by debug voip ccapi inout and chekc if stuck naywhere.

My voice setup is with CUCM 7.1 and MGCP voice gateway, just connecting FXO card in voice gateway will help me to call internal number of CUCM also.

Please give me URL for FXO configuration.