Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
299
Views
0
Helpful
1
Replies

[q] two stage LD dialing over ISDN PRI ?

lexxa7777
Level 1
Level 1

‎01-18-2010 05:30 AM - edited ‎03-15-2019 09:05 PM

Is it possible to implement following scheme of Long distance calls on CCME with PSTN over E1 ISDN PRI ?

Long distance call have to be dialed as:

<local_number_of_telephone_provider_7D><pause><pin_code><pause> <long_distance_number>

If PSTN is FXO line I can use  pause “,” in prefix but over IDSN PRI it is not possible?

Any ideas ?

Labels:
0 Helpful
1 Reply 1

Udit Mehrotra
Cisco Employee
Cisco Employee

‎01-18-2010 05:57 AM

In case of ISDN you will dial the PIN only once the ISDN Connect is recceived on the D Channels since only then does the two way cut through happens. The CME system would not offer such automated control to dial digits once the Call is connected.

You can achieve this by a TCL script on flash, though you will need to get one developed or try your hands at one yourself.

Check -

http://www.cisco.com/en/US/docs/ios/voice/ivr/configuration/guide/ivrapp01.html

HTH

--

Udit

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents