Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
504
Views
0
Helpful
1
Replies

Duplicate Active Signatures to Second Sensor

jonpwil1970
Level 1
Level 1

‎01-18-2010 09:14 AM - edited ‎03-10-2019 04:51 AM

I have 2 ASA-SSM-20 IPS modules on 2 different ASA 5520s.

I have setup the Signature Definitions for sig0 on Sensor 1 a certain way, how do I make those same policies apply to the sig0 on Sensor 2. I see that I can export the settings as a .csv from Sensor 1, but not how I can import them on Sensor 2?

Any help would be appreciated!

Labels:
0 Helpful
1 Reply 1

rhermes
Level 7
Level 7

‎01-18-2010 01:29 PM

There are several ways of accomplishing that goal. The most basic is from the

CLI. Log into Sensor 1 and display the full config (sh conf).

Log into sensor 2, get in the config mode (conf t) and paste in sensor 1's config for everything after the sig0 heading.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card