Check antennas status AP 1252 in lower power mode

Unanswered Question
Jan 19th, 2010
User Badges:

Hi all, I want to know how can I check the status of antennas of AP 1252 in lower power mode.

My customer has not yet the POE Plus switches so the AP can not make the most of use of all antennas. AP 1252 has 3 Rx and 2Tx antennas but it does not use all of them because it has not POE plus.

How can I see the antenna that are up? With the following command I can not get it: "show controller dot11 0". It only shows that AP is running in lower power mode.

Thanks by advance


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Leo Laohoo Tue, 01/19/2010 - 12:58
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Hi Fernando,

Upgrade the IOS to 12.4(10b)JDA3 (or later) and the 1250 should be able to operate both radio modules at 15.4w.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode