How to configure IPM alert in IPM 2.6 for Windows?

santipongv · ‎01-20-2010

I am trying to figure out if there is a way to configure IPM to send out an alert when the performace reaches or falls beyond certain threshold? In this case, I am trying to create a new HTTP operation. On the General tab > Latency Threshold Settings > Action Event Type, I select SNMP Trap & NMVT Alert. However, I did not see an option to configure where the alerts will be sent to, as well as, other alert settings. Thank you in advance.

Joe Clarke · ‎01-23-2010

IPM does not send out the alerts itself. Instead, the device will send an SNMP trap if the trigger condition is met. Where these traps are sent depends on your device configuration. Make sure you have defined at least one trap recipient on your IP SLA source device, and make sure that you have configured:

snmp-server enable traps rtr