cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
490
Views
0
Helpful
1
Replies

Changing the Native VLAN

Andy White
Level 3
Level 3

Hello,

I have a 802.1q trunk between a 2960 and 3750, VLAN 1 is being used for the trunk and management interface.  I'd liek to chaneg the Native vlan to 99 and the manage ment vlan to 100 on both, how can I do this?

Thanks

1 Reply 1

milan.kulik
Level 10
Level 10

Hi,

switchport trunk native VLAN 99

on bot trunk sides.

See http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_50_se/command/reference/cli3.html#wp1948736

To change the management VLAN you need to configure an IP address for int VLAN 100.

See "IP address" section in the same document, just replace int VLAN 1 in the example with int VLAN 100.

Just be careful, you could lose your switch connectivity when changing the IP address remotely.

If you are moving to a new subnet, you might need to change the default gateway, too, which might be tricky when the switch is placed in a remote site, e.g.

BR,

Milan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco