Can only console during startup...

Unanswered Question
Jan 21st, 2010
User Badges:

I have two new Cisco 2960G switches, and I must be doing something wrong because the only time I can successfully console

these switches is if I have the session open during the switch startup.  If I have the switch on already and try to connect, nothing happens, just a blank screen.  Is there some configuration change I need to make or set?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Itzcoatl Espinosa Thu, 01/21/2010 - 07:56
User Badges:
  • Cisco Employee,
  • Events Top Contributors,


Hi John,

You should not have any problem trying to connect through console. If you hit enter do you get any response?




This Discussion