AP Accross a NAT Network

Unanswered Question
Jan 21st, 2010


I have an AP1142 in a remote network with the IP All the traffic that go out this remote networks is NAT with the IP of the router When the AP tries to connect with the controller WLC 4402  ( its arrives with the IP of the router (because NAT) and the controller can not connect with it. Do anyone knows if its possible that the controller connect with the AP in this situation (NAT). If its possible could you pass me a guide explaining how to configure it?

Thank, regards.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode