Factory defaults terminal problem
As I mentioned in previous post I made a factory default reset,
now I connect to my console,
Serial type, speed 9600... Open
Now the black screen appears and I cant nothing write there... trying ctrl +c nothing helps..
The problem is on CISCO 2800 ROUTER
Your PC has IP address 192.168.80.2. Its default gateway shall be set to 192.168.80.1 (the IP address of the Fa0/1 interface on the router).
On the Fa0/0 interface of your router, you have the IP address 192.168.100.200. Then, your router should use the IP address 192.168.100.100 as its default gateway. This default gateway is configured on your router using the command ip route 0.0.0.0 0.0.0.0 192.168.100.100 in the global configuration mode (the "configure terminal" mode). If you entered any command of the form ip default-gateway then remove it using the no ip default-gateway command, as this command is not used on routers if IP routing is activated.
You are asking why your PC cannot ping the 192.168.100.100 address. Is the server at 192.168.100.100 aware that there is a network 192.168.80.0/24 which can be, from its viewpoint, reached via 192.168.100.200? If not then you will have to properly add an entry for this network into the routing table on that server or use NAT to hide the network 192.168.80.0/24 behind the IP 192.168.100.200.
would u like to enter initial configuration dialog ? yes/ no
what should i select?
I just wanna boot the web interface and so on.. and after that to configure
Select yes and then assign your 10.x.x.x address to one of the ethernet interfaces.