Controller T1 simulation

Unanswered Question
Jan 23rd, 2010
User Badges:

Hello Guys,


                I have 2 2621XM routers. Each of the routers have a T1 DSU/CSU card in each of them. I am trying to simulate configuring DS0-GROUPS and PRI-GROUPS on the controller interface but the only interface selcetion I get is the a serial interface representing the T1 cards when I check the sh run. I am looking for a controller interface like the one below. What am I not doing right?


controller T1 1/0
framing esf
clock source internal
linecode b8zs
pri-group timeslots 1-6,24

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
paolo bevilacqua Sat, 01/23/2010 - 22:01
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

The hardware that you have do not supports controller configuration, nor ds0 or pri group.

So you cannot use it for the purpose.

Charlie Mayes Sun, 01/24/2010 - 07:25
User Badges:

What do I need to do in order to

accomplish this? I thought that the 2621XM Routers with T1 Cards and Crossover cables would do that.

paolo bevilacqua Sun, 01/24/2010 - 11:18
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

You need NM-HDV-xxx cards for that.

Actions

This Discussion