01-23-2010 10:05 AM - edited 03-15-2019 09:11 PM
Hello Guys,
I have 2 2621XM routers. Each of the routers have a T1 DSU/CSU card in each of them. I am trying to simulate configuring DS0-GROUPS and PRI-GROUPS on the controller interface but the only interface selcetion I get is the a serial interface representing the T1 cards when I check the sh run. I am looking for a controller interface like the one below. What am I not doing right?
controller T1 1/0
framing esf
clock source internal
linecode b8zs
pri-group timeslots 1-6,24
01-23-2010 10:01 PM
The hardware that you have do not supports controller configuration, nor ds0 or pri group.
So you cannot use it for the purpose.
01-24-2010 07:25 AM
What do I need to do in order to
accomplish this? I thought that the 2621XM Routers with T1 Cards and Crossover cables would do that.
01-24-2010 11:18 AM
You need NM-HDV-xxx cards for that.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide