01-24-2010 10:43 AM - edited 03-14-2019 05:09 AM
HI All,
I have 2 UCCX Server running HA Mode, I know howto change UCCX IP address for single node but
I'm not sure about HA, Is there any special things that I need to do for changing IP Address in HA Mode?
Regards,
Tinnakorn
Solved! Go to Solution.
01-24-2010 12:24 PM
Hi Tinnakorn,
Assuming that you are asking w.r.t UCCX 7.0,
Refer to :
Cisco Unified CCX Administration Guide, Release 7.0(1) :
http://www.cisco.com/en/US/docs/voice_ip_comm/cust_contact/contact_center/crs/express_7_0/configuration/guide/uccx70ag.pdf
Pls follow the steps mentioned under section "Modifying Unified CCX IP Address Information (Page 327).".
Run postinstall.exe to configure ur CAD tp point to new IP address of CCX nodes.
And then, you are done. Its pretty simple and similar to the one that you know regarding modifying address for single node. But here, you need to perform this for all nodes.
Hope this clarifies. Good luck.
Regards,
Soman Nair.
(Pls rate if this helps)
01-24-2010 12:24 PM
Hi Tinnakorn,
Assuming that you are asking w.r.t UCCX 7.0,
Refer to :
Cisco Unified CCX Administration Guide, Release 7.0(1) :
http://www.cisco.com/en/US/docs/voice_ip_comm/cust_contact/contact_center/crs/express_7_0/configuration/guide/uccx70ag.pdf
Pls follow the steps mentioned under section "Modifying Unified CCX IP Address Information (Page 327).".
Run postinstall.exe to configure ur CAD tp point to new IP address of CCX nodes.
And then, you are done. Its pretty simple and similar to the one that you know regarding modifying address for single node. But here, you need to perform this for all nodes.
Hope this clarifies. Good luck.
Regards,
Soman Nair.
(Pls rate if this helps)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide